hydr-cutting source

C

Chris Hatin

Joined
Dec 20, 1999
Messages
123
Ken Onion made a post about using lazer, hydro-cut, etc. materials. From what I read, there didn't seem to be an issue with the replies, as long as the maker was honest about it, as RJ Martin pointed out. Here's a source I've used with terrific results.

LMS Stampings in Bethlehem (sp?) PA (610) 867-5011 Ask for Bill

Good guy to deal with.

I KNOW, I SPELLED HYDRO WRONG IN TTHE TOPIC.
------------------
Chris Hatin
hatintec@dellnet.com

www.geocities.com/chrishatin/hatintec.html

[This message has been edited by Chris Hatin (edited 23 December 1999).]
 
You must log in or register to reply here.
Back
Top