I am making a knife and wondering d2 or1095

[Lukers]

I am trying to decide whether to use d2 or 1095. I am having newt livesay grind and temper it and i was going to do all the finish work(handle, blade finish, sheath,etc) I guess i am kinda making it but not really. But anyway, I was wondering if you guys have had experience with d2? Is it noticeable better with edge holding and toughness? your comments would be much appreciated. By the knife was modeled after the busse steel heart. i decided to take a shot at drawing it. It is about an inch and a half longer than with same handle shape and blade shape.
thanks
Luke

 

[bald1]

Luke,

I'm going to shoot your thread over to the
Shop Talk Forum where most of the guys with knifemaking experience hang out. I'm sure they'll provide you with the solid counsel, advice, and wisdom you seek

!

------------------
-=[Bob Allman]=-

I did NOT escape from the institution! They gave me a day pass!

BFC member since the very beginning
AKTI membership pending
VHA and NRA member