I need my Endura to be shortened (it's too long to carry legally)

[maloosik]

I've asked Spyderco about this but they will not re-shape the blade, they will just keep the same shape and trim off 1/4". For $25 this is a pretty easy solution....BUT

I'd like to find someone that wants to exercise a little creativity with the blade shape while also shortening and of course sharpening.

Ideally the blade would look just like the Spyderco Centofante 3 or some variant of the Yojimbo 2 or a mix or ?

Most importantly it must be legal for me to carry so 3.5" max.

Is there anyone out there that can be recommended to do this sort of thing or should I just sent it to Golden?

 

[Senserazer]

I suppose most of the craftsmen here could do that for you, it's more a matter of pricing I think, if it makes sense financially.

 

[maloosik]

Well I was hoping to give someone a poke that may have an interest in taking this on, not sure where else to start...could anyone make a recommendation or point to a list?

 

[VictorKilo]

If you don't pick up any leads here, could try over in the Wanted: Knifemaker/Craftsman/Related Services sub-forum.

 

[Sonnemann]

Charlie Mike did my Delica for me

 

[singularity35]

 

[Phydeaux]

Where are you located? There may be a local forum member that would be willing to help you.

Ric

 

[tramp775]

+1 on what victorkilo said. If you can,, use a bladeforum member.

 

[maloosik]

I'm in Colorado. I'll try looking up Charlie Mike as suggested (thanks Sonnemann)

Where are you located? There may be a local forum member that would be willing to help you.

Ric