Idea on Sharpener!

E

EW

Joined
Jun 28, 1999
Messages
120
Don't know if anyone thought of this before. Sal, can you make a ceramic bit that fit on a Dremel, the sizes of the bits are for sharpening Spyder Edge, maybe two in a set, one for large tooth and on for small tooth, and maybe there can be an angle guide too. I got the idea when I saw a chain saw sharpening ket from dremel. Just an idea!!

This is a chain saw sharpening attachment kit offer by dremel.
1453.gif
 
EW - Ceramic loads up fairly quickly when used with a power source. You would have to have a very simple effective way of removing the material from the ceramic stone. The normal Dremel bits are fryable and wear away rather than load up.

sal
 
You must log in or register to reply here.
Back
Top