I'm looking for someone who can drill pocket clip holes in titanium...

C

ChrisDS

Feedback: +3 / =0 / -0
Joined
May 3, 2010
Messages
64
I have a Benchmade G10 Pika 2 and it's a beautiful knife (at least this one is) but the pocket clip is the worst I've ever seen/used. Can anyone out there drill holes and mount a DLC Griptillan pocket clip for me? I would pay you for the work of course and I have the pocket clip that I would send with the knife...

I'm not sure if this was an ok place to post this... but I really couldn't find anywhere else. Thanks!

e-mailing me is a good way to contact me... qlcmusic@hotmail.com (I will check the forums but not as often as e-mail)
 
Post over in the services needed/offered section of the exchange. Anyone with a drill press and small tap set can do this for you... Or go find your local gunsmith...
 
Thanks for the response, I will try services first, I'd prefer to have someone who's done it many time before.
 
You must log in or register to reply here.
Back
Top