1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

In the shop 10-31-2015

Discussion in 'Art In Stone' started by Redrummd, Nov 1, 2015.

  1. Redrummd

    Redrummd Moderator Moderator

    May 21, 2007
    I am working on three top end Dinosaur Bone Buck 110's for a collector who sent me two Buck knives with factory Damascus blades. I have not seen these 4 pin frames before and one was even more unusual in that the two pin holes were filled and two had threaded pins. In addition to the weird frames and threaded pins an adhesive was used that was like nothing I had seen before. IT was VERY tough to break loose even after heating the knife to the point I had to wear gloves to work with it. The adhesive wouldn't even dissolve in goof off - I had to pretty much use a pick and razor blades to get it off AFTER soaking in goof off.

    Have any of you seen anything like these from the factory before?
     

    Attached Files:

  2. Redrummd

    Redrummd Moderator Moderator

    May 21, 2007
    Here are photos of the Dinosaur Bone that was selected by the collector for the three knives.
     

    Attached Files:

  3. kraash

    kraash

    218
    May 26, 2010
    I wasn't aware that there was a such thing as factory Damascus 110s ?
     
  4. hohenstreetroa

    hohenstreetroa Gold Member Gold Member

    314
    May 22, 2010
    Buck made the 110DM stag/damascus in the late 80's. There was also a red or brown bone handled version made. You can still occasionally find them on popular online auction sites, but they are usually pricey!
     
  5. Redrummd

    Redrummd Moderator Moderator

    May 21, 2007
    Here are photos of them finished!
     

    Attached Files:

  6. hohenstreetroa

    hohenstreetroa Gold Member Gold Member

    314
    May 22, 2010
    Absolutely gorgeous! If your buyer backs out, let me know!
     

Share This Page