This one is sold pending funds, thanks
I decided to change the bolsters on this knife to a more traditional look. I think it fits the style of the knife better. The knife opens and closes smoothly. It can be easily thumb flicked open or slow rolled in the usual manner. Lock up is positive with absolutely no movement in any direction. The cpm D2 blade is centered and shaving sharp at a tested 59-60 rc. The detent is positive for a worry free carry. Here are the specs:
Closed- 3 3/4 inches
Open- 6 3/4
Blade- 3 inches to bolsters
Steel- cpm D2 x 5/32
Grind- Flat with swedge
Finish- Stonewashed
Frame- .070 anodized Titanium
Bolsters- Brushed 440c stainless
Scales- AAA Desert Ironwood Burl
Clip- .040 anodized and carved titanium. Deep ride clip set up for tip up right hand carry
Pivot- 3/16 stainless with caged bearings.
Stop Pin- 1/8 hardened stainless
Back Spacer- Stippled Carbon Fiber
Asking 310.00 shipped in the USA
Paypal preferred but USPS M/O just as good.
Questions or comments welcomed
Thanks for looking
If you look closely below you can see where I got a little close where I counter sinked the screw head under the scale when I was finishing this one.
I decided to change the bolsters on this knife to a more traditional look. I think it fits the style of the knife better. The knife opens and closes smoothly. It can be easily thumb flicked open or slow rolled in the usual manner. Lock up is positive with absolutely no movement in any direction. The cpm D2 blade is centered and shaving sharp at a tested 59-60 rc. The detent is positive for a worry free carry. Here are the specs:
Closed- 3 3/4 inches
Open- 6 3/4
Blade- 3 inches to bolsters
Steel- cpm D2 x 5/32
Grind- Flat with swedge
Finish- Stonewashed
Frame- .070 anodized Titanium
Bolsters- Brushed 440c stainless
Scales- AAA Desert Ironwood Burl
Clip- .040 anodized and carved titanium. Deep ride clip set up for tip up right hand carry
Pivot- 3/16 stainless with caged bearings.
Stop Pin- 1/8 hardened stainless
Back Spacer- Stippled Carbon Fiber
Asking 310.00 shipped in the USA
Paypal preferred but USPS M/O just as good.
Questions or comments welcomed
Thanks for looking
If you look closely below you can see where I got a little close where I counter sinked the screw head under the scale when I was finishing this one.
Last edited:
