Ironwood BackPacker

J

J. Hoover

Feedback: +61 / =0 / -0
Joined
Jul 2, 2006
Messages
1,782
This one is SOLD thanks

I had a short piece of 1/4 inch 5160 left over that needed to be used. What I came up with is this small full tang drop point design. It's flat ground to .010at the edge, scary sharp and tough as nails. This one will make a good backpack/hiker companion or woods knife. Here are the specs:

Steel- 5160 X 1/4
Grind- flat
AOL- 7 3/4 inches
Blade- 3 1/2 inches to the plunge cut
Scales- Desert Ironwood
Stainless tubes
Kydex sheath with Tek-Loc vertical or horizontal carry right ot lefthand.
Asking 145.00 shipped in the USA or Canada
Paypal, Certified check, or USPS M/O preferred
Comments or questions welcome
Thanks for looking

010-9.jpg


011-4.jpg


012-4.jpg


014-4.jpg


015-3.jpg
 
Last edited:
Just like to add that if you would prefer a leather sheath for this I can do a pouch style from 8-9 ounce vegetable tanned leather to replace the kydex pictured for the same price. Your choice left or right carry.
 
interesting design, Joe.
I can see a family resemblance to the two Hoover knives I have, but at the same time quite different.
What is the purpose of the hole at the front of the handle?
 
Thanks fasteer, the hole is mainly cosmetic, but could be used to secure the knife to a pole if needed in a tough situation.
Joe
 
You must log in or register to reply here.
Back
Top