Is it slip joint?

[Arathol]

Thank you for pointing out, and sorry that I didn’t say clearly. The surface of white part is 3D printed.

The surface is 3D printed or the whole white section? I didn't know you could 3D print just the surface.....

 

[JINKNIVES]

The surface is 3D printed or the whole white section? I didn't know you could 3D print just the surface.....

Yes, only the surface of the white section is 3D printed (I mean, the whole handle is black G10, but the surface of white part is 3D printed, just a layer of white on black G10, like coating, camo). 3D printed creates more possibilities, though. We want this pocket knife to look like “penguin”, 3D printed did it. We can’t find the same look in multi-color G10, or if we do, it must cost a lot.

 

[Arathol]

Yes, only the surface of the white section is 3D printed (I mean, the whole handle is black G10, but the surface of white part is 3D printed, just a layer of white on black G10, like coating, camo). 3D printed creates more possibilities, though. We want this pocket knife to look like “penguin”, 3D printed did it. We can’t find the same look in multi-color G10, or if we do, it must cost a lot.

OK, so you apply a 3D printed overlay on the G10 hande....maybe you should make that a bit clearer in your sales pitch....