DEllis
Part Time Steel Basher
- Joined
- Oct 17, 2007
- Messages
- 966
What kind do you have now? Which would you recommend? I spent a good amount of time looking at the various options before an assingment in Canada (Calgary) made the issue moot. Wouldn't mind following up on that idea now that I'm back in the shop in Texas.
Love the knife too, though I tend to side with Kevin.
I just have Gunline brand checkering tools that I bought from Brownell's , but you can get carbide cutters for them or the other brand........Dem-Bart IIRC. This was done 22 LPI, and would have been a lot easier at 18LPI. If you have not done any checkering, get the lower line count ones to start with and a few of the needle files for pointing up the diamonds, they tend to get dulled after not too long working with harder materials.
I have never used the carbide tools so can't make any recommendations there, but they should stay sharp much longer.
Thanks for the comment.
Thanks Mark and AVigil.
Darcy
