Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
Hello folks , This new finished all purpose knife has a high hollow grind on 5/32" A -2 Tool steel bar stock , it has a fine scotch-brite belt satin finish .
It was heat treated to an Rc. 61-62 with a sub-zero quench .
The overall length is 7" , blade tip to handle is 3" with a 2-3/4 cutting edge , it is 1-1/8" edge to spine .
Handled in new vintage paper micarta , with yellow liners , Brass Corby bolts and lanyard tube . A center and end mosaic pin .
Sheath is right hand carry .
$160.00 includes shipping in the USA , international shipping write for cost .
Pay-pal , postal m/o, or check held to clear . My PP is sandlot@charter.net
Hope you all like it and comments are always welcome .
It was heat treated to an Rc. 61-62 with a sub-zero quench .
The overall length is 7" , blade tip to handle is 3" with a 2-3/4 cutting edge , it is 1-1/8" edge to spine .
Handled in new vintage paper micarta , with yellow liners , Brass Corby bolts and lanyard tube . A center and end mosaic pin .
Sheath is right hand carry .
$160.00 includes shipping in the USA , international shipping write for cost .
Pay-pal , postal m/o, or check held to clear . My PP is sandlot@charter.net
Hope you all like it and comments are always welcome .
