Hay boys, recently acquired my first A10 back, it wasnt what the customer was wanting. I did some modifications to the lockup and put a new pivot system in it, as it had some play in it, it now locks up perfectly. this knife still had the original edge on it and was not used as far as I can tell, so it is being sold as new. This is one of 3 that I put out that has BP bushings instead of a bearing system, its butter smooth and locks up clean.
"A10"
New offering from Jake Hoback Knives
http://jakehobackknives.com/
Spec's:
CPM154CM
Heat treat in house @ RC 61
.130" thick blade, flat grind, hand-rubbed to 400 grit and then long term acid etched for a matte finish, then stone washed for industrial look.
3.5" long blade
4.75" long Handle
Handles are .200 thick 6al-4v titanium, stone washed, and machined
All hardware is 416 stainless, pivot, stop pin, and rear most spacer are hardened, screws are stainless 2-56, stainless dual thumbstuds
Shipping included, insurance will be extra, I can not be held liable for the blade once it leaves my hands unless you purchase insurance. Out side of the USA please contact for shipping.
If you plan to pay with paypal please add 3% to cover fees
First "I'll take it" gets it
Sold!!!$300
"A10"
New offering from Jake Hoback Knives
http://jakehobackknives.com/
Spec's:
CPM154CM
Heat treat in house @ RC 61
.130" thick blade, flat grind, hand-rubbed to 400 grit and then long term acid etched for a matte finish, then stone washed for industrial look.
3.5" long blade
4.75" long Handle
Handles are .200 thick 6al-4v titanium, stone washed, and machined
All hardware is 416 stainless, pivot, stop pin, and rear most spacer are hardened, screws are stainless 2-56, stainless dual thumbstuds
Shipping included, insurance will be extra, I can not be held liable for the blade once it leaves my hands unless you purchase insurance. Out side of the USA please contact for shipping.
If you plan to pay with paypal please add 3% to cover fees
First "I'll take it" gets it
Sold!!!$300
Last edited:
never fear man