- Joined
- Dec 24, 2012
- Messages
- 119
JRP Prototype Flipper 1/1
It has beautifully smooth action and its only on washers, Jared has mentioned to me that for a nominal fee he would likely be able to put bearings into it. The scales are G10, it has Titanium liners and a 154CM blade with an incredible raw finish on the top portions. There is nothing at all wrong with the blade just not suiting the role I wanted it for. It is a bit off center, but Jared has said he would fix that at no cost but I figure thats noteworthy, it doesn't affect any functionality though. I have carried this and cut some tape, but that is quite literally it.
As far as trades, I am looking for a mid-sized flipper, on bearings, that isn't too bulky. I am a big fan of Kirby Lambert and Ray Laconico so those would seal the deal right then. However, am open to any offer, just mostly interested in bearing pivot flippers
Thanks.
It has beautifully smooth action and its only on washers, Jared has mentioned to me that for a nominal fee he would likely be able to put bearings into it. The scales are G10, it has Titanium liners and a 154CM blade with an incredible raw finish on the top portions. There is nothing at all wrong with the blade just not suiting the role I wanted it for. It is a bit off center, but Jared has said he would fix that at no cost but I figure thats noteworthy, it doesn't affect any functionality though. I have carried this and cut some tape, but that is quite literally it.
As far as trades, I am looking for a mid-sized flipper, on bearings, that isn't too bulky. I am a big fan of Kirby Lambert and Ray Laconico so those would seal the deal right then. However, am open to any offer, just mostly interested in bearing pivot flippers
Thanks.