This is made from about 4mm thick planer blade that I got from my father in law who was a millwright in a lumber mill. There is one small area of pitting on the back/flat side that I couldn't grind/sand out. (It was in a lumber mill after all) You don't really notice it much though cause I bead blasted and stonewashed the whole thing to give it a little more rust and scratch resistance.
JPT
Blade 3 3/4" chisel ground, 8" overall.
Sheath is kydex .060 with a .090 loop set up for crossdraw right hand carry.
OD Green camo G10 (AKS) with ss pins for the handles.
Asking 170 shipped to you, paypal djfrazee@gmail.com (I prefer paypal personal since I don't have to pay the fees. I always ship insured too.)
Lifetime common sense warranty- A knife is for cutting not a prybar or screwdriver!
Dan
JPT
Blade 3 3/4" chisel ground, 8" overall.
Sheath is kydex .060 with a .090 loop set up for crossdraw right hand carry.
OD Green camo G10 (AKS) with ss pins for the handles.
Asking 170 shipped to you, paypal djfrazee@gmail.com (I prefer paypal personal since I don't have to pay the fees. I always ship insured too.)
Lifetime common sense warranty- A knife is for cutting not a prybar or screwdriver!
Dan
