kellam knives questions

[Nathan Akins]

does anyone what steel and edge angle used in the wolverine?

 

[Bigfattyt]

Adanantium.... 18 degrees inclusive on each claw....

 

[Thomas Linton]

Kellam is a retailer, not a maker, although it has some models made exclusively for its brand.

Most people believe the Kellam "Wolverine" is made by Ahti and has a differentially heat treated Lauri blade. Lauri calls the blade Lauri PT (progression tempered). The edge area is said to be 62 RC.

The steel is probably Carbon-Vandium steel from Böhler-Uddeholm. C-0.81 Mn-0.56 S-0.004 P-0,01 Si 0.35 V-0.161 Cr-0.54

 

[Leftytwogunz]

Adanantium.... 18 degrees inclusive on each claw....

I haven't LOL on an internet post in a long time. Too funny.

 

[LukeTheSpook]

I think I have one of these. It's a nice blade. Scandi grind. So....0?

 

[Nathan Akins]

But does anyone know what steel used in this knife

 

[Thomas Linton]

But does anyone know what steel used in this knife

The steel is probably Carbon-Vandium steel from Böhler-Uddeholm. C-0.81 Mn-0.56 S-0.004 P-0,01 Si 0.35 V-0.161 Cr-0.54

 

[Nathan Akins]

Oh sorry, didn't see that up there until now, thanks!

 

[Nathan Akins]

I looked carbon vanadium on their websit e and couldn't find it, so do you possible have the name?

 

[onojoe]

Nice knife, many of the Swedish/ finish knives simply call it carbon steel. If I were to guess I would say Bohler-Uddeholm UHB20C Steel used by a lot of scandanavian knife makers