About a week ago or so Knifehead ran a thread in traditionals on clean bone (no dye, or jigging) and I've been sitting on this stuff since last August. O K so I live in a papermill town and last August there was a drawdown for dam repair. I took off for an old slaughterhouse site that had been under water for 60 years and this is some of it. I'm pretty sure its from a cow. Stabilized twice and drying since last August. Nuked it in a ziploc = 0 vapor.
Specs
Blade and spring ATS-34, cryo quenched, Rc-62, 3/32" stock.
Blade is hollow ground, 600 grit hand finish, Cut swedges.
Liners, bolsters, and pins, stainless steel, liners are mill releived.
Scales Natural color shin bone.
Back is flush open, half stop, and closed positions.
Closed length 4" Open 7 1/4" About 5 on the pull open scale.
SOLE AUTHORSHIP All parts made by me in my shop.(USA)
Price $350 shipping and paypal included. SOLD
You can say I'll take it here, pm, or email me. All comments welcome
and thanks for looking.
Ken
[/IMG]
Specs
Blade and spring ATS-34, cryo quenched, Rc-62, 3/32" stock.
Blade is hollow ground, 600 grit hand finish, Cut swedges.
Liners, bolsters, and pins, stainless steel, liners are mill releived.
Scales Natural color shin bone.
Back is flush open, half stop, and closed positions.
Closed length 4" Open 7 1/4" About 5 on the pull open scale.
SOLE AUTHORSHIP All parts made by me in my shop.(USA)
Price $350 shipping and paypal included. SOLD
You can say I'll take it here, pm, or email me. All comments welcome
and thanks for looking.
Ken
Last edited:
