Ken Coats 4" Jack

kc custom

kc custom

Feedback: +43 / =0 / -0
Joined
Apr 20, 2005
Messages
2,351
This one turned out very smooth, the blade lays dead center, and the
black jigged bone has gray undertones.

SPECS
Blade and spring Ats-34, cryo quenched, Blade @ Rc 61-62, 3/32" stock.
Blade is hollow ground, 600 grit hand finish, cut swedges.
Frame 410 stainless steel milled from plate, liners and bolsters integral,
liners are mill relieved.
Scales my dyed and jigged bone, Acorn shield is pinned.
Back is flush open, closed, and half stop position. About a 5 on the pull
open scale
Closed length 4", open length 7 1/4", Standard nail nick.

SOLE AUTHORSHIP All parts made by me in my shop.

Price $375 shipping and paypal included. SOLD
You can say I'll take it here, pm, or email me.
All comments welcome and Thanks for looking.
Ken.

100_0785_edited-1.jpg
[/IMG]
 
Last edited:
Nice knife and great score, did not even see it before it was gone.
Congratulations to both of you,
Jim
 
"Comments": super, super nice !
Ken i am always impressed especially by the incredible point you are able to get on your blades. i find many small everyday jobs require a good point and yours are way beyond just "good".
roland
 
Thanks for the welcome Alfaholic. This is my first KC and I am looking forward to getting it in my hands.
 
Last edited:
I received the knife today and it's better than i thought it would be. Thanks again and I'm sure I'll be getting another in the future.
 
You must log in or register to reply here.
Back
Top