KEN ERICKSON 3 3/8 jack

ken erickson

ken erickson

Knifemaker / Craftsman / Service Provider
Feedback: +18 / =0 / -0
Joined
Aug 27, 2004
Messages
2,701
Ken Erickson 3 3/8 jack

SOLD $395 conus Paypal fees included​

I made this small jack up on what would basically be a junior stockman pattern as its shorter than 3 1/2 inches.
This knife features a slender well rounded frame that is very pocket friendly. I also went with a slender clip blade sitting low in the frame when closed. Blade nicely centered, good walk and talk.Thanks for looking ! You can say "I will take it" here, pm or email me. All my knives are sole-authorship including heat treat.

3 3/8 closed
ATS-34 flat ground blade with satin finish 3/32 stock
Standard nail pull
Cut swedges
410 integral frame/bolsters
Inside frame relieved/cleaned bright
Shield pinned
My dyed and jigged bone scales
Satin finish on sides of bolsters with bright finish on end bevels
Half stop
Medium pull
1 5/8 oz.

IMGP4173_edited-1.jpg

IMGP4177_edited-1.jpg

IMGP4178_edited-1.jpg

IMGP4176_edited-1.jpg

IMGP4179_edited-1.jpg

IMGP4174_edited-1.jpg

IMGP4175_edited-1.jpg
 
Last edited:
Ken, that one's "da bomb" (so to speak). :cool: :thumbup:
 
another great knife Ken-I almost thought I had a chance at this one when I saw it earlier, but late to the dance-again-good get Vince!!!
 
Ken,
Whats the deal???? You are slipping.....almost 25 minutes....Oh My!

Just teasing....... another gorgeous piece!!!!!:thumbup:
 
Stunning knife Ken:thumbup: I always arrive just a little to late.......:(
 
Nice catch Vince. You're lucky I was on the road somewhere between Durango and Fayetttville when this one hit the board. :)

Another very fine folder there Ken. :thumbup:
 
Vince,

Great Grab! Oh My! Is that ever nice.

Ken, another great slippie. Your jigging is supurb! :thumbup: (SP):confused:

Kent
 
ken erickson said:
Thanks Vince! pm sent.

Ken
Click to expand...

:thumbup: Looked great to me,I like the size on this It fell under the "No Brainer" purchase category.If you know Ken's knives,you know :D


Thank You,too,Ken,
-Vince
 
You must log in or register to reply here.
Back
Top