Kershaw factory edge?

I've found them to be close to 15-degrees per side. At least close enough that reprofiling to that isn't too difficult.
 
John79 said:
Ok, so does this knife respond well to the Sharpmaker, with its factory edge?
Click to expand...


Yes it does. Try 30-degrees first to see if you're getting to the edge. If it's not quite there and you don't want to re-profile, go to the 40-degree setting. The steel performs well at 30.
 
Phillip Dobson said:
Yes it does. Try 30-degrees first to see if you're getting to the edge. If it's not quite there and you don't want to re-profile, go to the 40-degree setting. The steel performs well at 30.
Click to expand...

+1

30* works well on most of my kershaw folders
 
You must log in or register to reply here.
Back
Top