Kiln question...

[therron258]

Thinking long term here...

Is this a good all around kiln for heat treating?

Ramp master is desirable over set pro correct?

Am I reading right or is this not the one that comes with the rampmaster? Reason I ask is it is cheaper than other sites.

Also, I've got my KMG running on a 20A 240V circuit breaker of its own dedicated outlet... Would that breaker handle this oven?

Here is the one I'm looking at: even heat KO 22.5 from USA Knifemaker...1089 says with ramp master

 

[Stacy E. Apelt - Bladesmith]

That oven is specified as 240V 15A, so your breaker should be fine. It is a good oven and the Rampmaster is a good controller.

http://usaknifemaker.com/heat-treat...at-ko-22-5-9-wx5-5-hx22-5-d-w-rampmaster.html

 

[therron258]

Thank you Stacy, I could not pull up all of the information from my phone.