Phillip Patton
Knifemaker / Craftsman / Service Provider
- Joined
- Jul 25, 2005
- Messages
- 5,344
If I recall, the ram/die weight is 60#, and I have a 20 pound weight that bolts onto the front of the ram for some extra umph.
The cylinder is 2" X 10". The dies are 2" X 4". Comes with three sets of dies. Flat, drawing, and combo.
The I-beams used for the frame are quite a bit heavier than the plans called for.
I'll post some pictures of it in the morning.
Requires at least 17 CFM air compressor.
Local pickup only. (North East Indiana)
Great work saver, and very controllable.
Asking $1000
Thanks for looking!
Phillip
The cylinder is 2" X 10". The dies are 2" X 4". Comes with three sets of dies. Flat, drawing, and combo.
The I-beams used for the frame are quite a bit heavier than the plans called for.
I'll post some pictures of it in the morning.
Requires at least 17 CFM air compressor.
Local pickup only. (North East Indiana)
Great work saver, and very controllable.
Asking $1000
Thanks for looking!
Phillip
Last edited:
