knife blank

buckmaster96

buckmaster96

Feedback: +2 / =0 / -0
Joined
Jan 6, 2012
Messages
794
IMG_0001_NEW_NEW_NEW.jpg

i need someone thats willing to make this knife out of either s35vn s90v or elmax (prefferably elmax). i do not want it to be sharpened all i want is the holes drilled the shape cut out and beveled. the thickness is 1/8" and yes i meant to have the recurve in there. please email me if you have any concerns or are interested in doing this. i can send more details if needed and also the blade height at the highest point is just over 1" so it would need to be a 1 1/2" wide piece of steel. also i would like to get this for under forty dollars but could sway a little if need be
 
A bar of S35VN to make that is 30.00 plus shipping.To be realistic it's probably gonna cost 2-1/2 times what your willing to spend.

Stan
 
A piece of S90V for what you need would be $32 plus shipping and then pay for the grinding. Your budget may need to change or pick a cheaper steel.
 
buckmaster96 said:
what would you charge after grinding
Click to expand...

I'm not a "knifemaker" per say. I'm only offering you advice as the your steel choices are not cheap. I couldn't even guess on what a knifemaker would charge to cut a blank and grind it down for you. I'd expect to pay $50 at least on top of the cost of materials but then again I'm pretty slow at grinding steel ;)
 
You must log in or register to reply here.
Back
Top