Kwaiken - repost - been spoken for -sold

[Jack O'Neill]

Hello all , I recently finished up my take on a Kwaiken , this was a design that a customer had me make for him and I liked it , hope you all do also .

This is hollow ground from 1/8" A-2 tool steel , heat treated to an Rc. 61-62 with the cyro sub-zero quench and a very fine scotch-brite belt finish .
O.A.L is 7-1/4"
Blade - tip to handle is 3-1/2" with the cutting edge at 3" , 3/4" wide at the ricasso .
Handled up in Stabilized Katalox Burl , Blue liners , copper Corby bolts and a center mosaic pin .
$ 140.00 with no sheath or $165.00 with a pocket or belt carry leather sheath .

with free shipping in the USA , Pay-pal , postal m/o or check held to clear .My PP is sandlot@charter.net
Thanks for viewing my offerings and comment welcome .

Jack O'Neill
e-mail for questions , sandlot@charter.net
____________
To view past work , go to photobucket

http://s550.photobucket.com/albums/ii409/oneill_2009/

Quote Reply
Report Edit

 

[jfk1110]

Neat.one!!!

 

[Grady slaughter]

Those scales are nifty looking and no doubt look even better in person on this immaculate grind you have here. Just for me, someday post one with a small booboo of some sort. Hmm, you would probably have to mess something up on purpose though. Never mind.