Kwaiken

Jack O'Neill

Jack O'Neill

Gold Member
Feedback: +177 / =0 / -0
Joined
Nov 15, 2007
Messages
7,176
Hello all , I recently finished up my take on a Kwaiken , this was a design that a customer had me make for him and I liked it , hope you all do also .

This is hollow ground from 1/8" A-2 tool steel , heat treated to an Rc. 61-62 with the cyro sub-zero quench and a very fine scotch-brite belt finish .
O.A.L is 7-1/4"
Blade - tip to handle is 3-1/2" with the cutting edge at 3" , 3/4" wide at the ricasso .
Handled up in Stabilized Katalox Burl , Blue liners , copper Corby bolts and a center mosaic pin .

$ 145.00 with no sheath or $160.00 with a pocket or belt carry leather sheath .

with free shipping in the USA , Pay-pal , postal m/o or check held to clear .My PP is sandlot@charter.net
Thanks for viewing my offerings and comment welcome .

IMG_7928-2.JPGIMG_7930-2.JPGIMG_7935-2.JPGIMG_7936-2.JPGIMG_7938-2.JPGIMG_7939-2.JPGIMG_7942-2.JPGIMG_7946-2.JPG
 
Wow. This is the sort of knife I can fantasize about, both having it to mess with whenever I want, cutting and slicing or just admiring it.
I bet one could spend a lot of time looking into the depths of those amazing scales and not get bored. No secret I admire your work, but this one looks exceptional.
 
Grady slaughter said:
Wow. This is the sort of knife I can fantasize about, both having it to mess with whenever I want, cutting and slicing or just admiring it.
I bet one could spend a lot of time looking into the depths of those amazing scales and not get bored. No secret I admire your work, but this one looks exceptional.
Click to expand...
Thanks Grady , always good to hear from you . I appreciate the comments .
 
You must log in or register to reply here.
Back
Top