Large fighter in snakeskin Damascus and fossil Walrus ivory "SOLD"

DanGraves

DanGraves

Knifemaker / Craftsman / Service Provider
Feedback: +112 / =0 / -0
Joined
Mar 5, 2006
Messages
2,677
Hello folks. Here is a snake skin Damascus knife which is made out of 1/8th inch ball bearings and 4800 KC steel. All fittings are snakeskin Damascus. Makes for a hell of an edge holder so its not just about the looks. Ball bearings are very high carbon steel made to be tough. There are alignment pins in the ferrule and handle. The handle is one of the best I have ever received and has a natural end as it came out of the ground. One side was face up to the sun and the other down. It has a crackle effect. It should be the best as I spent 275.00 for it. I made all the Damascus and the cost was about 100.00. It took 5 days to build. The blade that is 10 1/4 inches and overall is 15 1/4 inches. The blade is a 1/4 inch thick at the guard and tapers to point. Very comfortable in right or left hand. Comes with stand and I can have a quality sheath made for about 80.00 or more for in-lade snakeskin which I will have to get quote on. Hope you like it as I enjoyed making it. It is 600.00 plus 12.00 for priority mail. My paypal and e-mail is dangraves4923@earthlink.net

Cant be mailed to New Jersey or New York due to laws. "SOLD"








 
Last edited:
Absolutely love this artistry. I am more into fighting knives due to my job and would consider purchasing one at some point if it met my style. Awesome knife
 
Thanks Gents. Tried to do the handle justice as I have never seen crackle fossil walrus. Have seen it in mammoth ivory.
 
You must log in or register to reply here.
Back
Top