Phillip Patton
Knifemaker / Craftsman / Service Provider
- Joined
- Jul 25, 2005
- Messages
- 5,344
Hey all,
Just finished this one up. It was for a customer, but turned out a bit longer than they wanted, so I'm posting it here.
Steel: O1 and L6 in a butterfly pattern. About 300 layers.
Hardness: 61.5 Rc
Blade length: 9.5"
Total length: about 15"
Blade thickness: around 3/16" at the bolster, with distal taper. Blade is about 2" wide.
Handle material: Desert ironwood
Fittings: stainless bolster and pin.
Flat grind with a convex edge.
Price: $ sold
I can take paypal, check, or MO. Please send paypal to 2000pjp at gmail dot com
If using a check, allow 10 business days for it to clear before shipment. Please make sure knife is still available before sending payment.
Thanks for looking!
Just finished this one up. It was for a customer, but turned out a bit longer than they wanted, so I'm posting it here.
Steel: O1 and L6 in a butterfly pattern. About 300 layers.
Hardness: 61.5 Rc
Blade length: 9.5"
Total length: about 15"
Blade thickness: around 3/16" at the bolster, with distal taper. Blade is about 2" wide.
Handle material: Desert ironwood
Fittings: stainless bolster and pin.
Flat grind with a convex edge.
Price: $ sold
I can take paypal, check, or MO. Please send paypal to 2000pjp at gmail dot com
If using a check, allow 10 business days for it to clear before shipment. Please make sure knife is still available before sending payment.
Thanks for looking!
Last edited:
