Hi again all...here's a slipjoint that I made with screw together construction. Hope you like it:
Blade and backspring are S30V stainless -blade is hollow ground
I blackened the blade and backspring by bead blasting and then etching (always trying something new)
Frame is jeweled/anodized titanium (0.050" thick)
Mill relieved around pivot
Handles are black G10 -also bead blasted for a nice grippy feel
Spring is "crisp" but not a nail breaker ...there is no half stop
I installed a stop pin so there is no bouncing of the blade against the backspring when you close the knife
Large shield is 410 stainless -double pinned, hammered, and bead blasted
Stainless screws and shadow washers
Leather lanyard
Overall length is a little over 8 1/2"; blade is 3 7/8" tip to frame
Price is $295 (SOLD) shipped in the U.S. Paypal works or can PM for other options. First "I'll take it" does. Comments/questions always welcome. Thanks for the look! -Phil
Blade and backspring are S30V stainless -blade is hollow ground
I blackened the blade and backspring by bead blasting and then etching (always trying something new)
Frame is jeweled/anodized titanium (0.050" thick)
Mill relieved around pivot
Handles are black G10 -also bead blasted for a nice grippy feel
Spring is "crisp" but not a nail breaker ...there is no half stop
I installed a stop pin so there is no bouncing of the blade against the backspring when you close the knife
Large shield is 410 stainless -double pinned, hammered, and bead blasted
Stainless screws and shadow washers
Leather lanyard
Overall length is a little over 8 1/2"; blade is 3 7/8" tip to frame
Price is $295 (SOLD) shipped in the U.S. Paypal works or can PM for other options. First "I'll take it" does. Comments/questions always welcome. Thanks for the look! -Phil
Last edited:
