Less than 20usd edge pro clone (minus stones)

D

diff_lock2

Joined
Jun 28, 2009
Messages
146
So, I built V1 of the sharpening jig. Used around 80g PLC plastic, most of it went into that support structure for the vertical rod. The aluminium profiles were about 5 bucks per meter and I was able to cut them at the hardware store. The base is some flower pot holder and the clamp is off a broken table light.

Now I am looking for cheap stones, need a intermediate grit from that rough file to the spyderco pocket stone.

sharpening_jig_edge_pro_clone0141024x575.jpg


sharpening_jig_edge_pro_clone011575x1024.jpg


sharpening_jig_edge_pro_clone0081024x577.jpg


sharpening_jig_edge_pro_clone0091024x575.jpg


sharpening_jig_edge_pro_clone0121024x578.jpg


sharpening_jig_edge_pro_clone0191024x576.jpg


sharpening_jig_edge_pro_clone0201024x575.jpg


sharpening_jig_edge_pro_clone0181024x576.jpg


sharpening_jig_edge_pro_clone0171024x576.jpg


sharpening_jig_edge_pro_clone0161024x576.jpg


sharpening_jig_edge_pro_clone0151024x576.jpg


sharpening_jig_edge_pro_clone0231024x575.jpg


sharpening_jig_edge_pro_clone023-Copy1024x574.jpg
 
Last edited:
Well done.

Ask around for broken stones and sharpmaker rods to complete your economical sharping tool.
 
You must log in or register to reply here.
Back
Top