Deathgrips (DOAT) scales in lightning strike carbon fiber for Benchmade 940
Like new. These were installed for a short time but the knife was not used or carried in that time. Fit and finish is perfect. There are a couple of slightly sharp spots where an end of the copper wire has lifted a bit, as expected from the material. Can be glued or sanded down if needed. Easy work.
Last picture shows how they look installed. Obviously, the knife and hardware are not included in the sale. Just the two scales.
Scales are a direct replacement for the 940-1, 940-2 and similar models with barrel spacers. For the 940, 943, etc. you will need to source barrel spacers and screws. I have a set of DOAT steel spacers (see below) that I will include. I don't recall getting a set of screws with them, but if I can dig up a spare set, I'll include them.
$ to your door in the U.S.
No trades, please.
Like new. These were installed for a short time but the knife was not used or carried in that time. Fit and finish is perfect. There are a couple of slightly sharp spots where an end of the copper wire has lifted a bit, as expected from the material. Can be glued or sanded down if needed. Easy work.
Last picture shows how they look installed. Obviously, the knife and hardware are not included in the sale. Just the two scales.
Scales are a direct replacement for the 940-1, 940-2 and similar models with barrel spacers. For the 940, 943, etc. you will need to source barrel spacers and screws. I have a set of DOAT steel spacers (see below) that I will include. I don't recall getting a set of screws with them, but if I can dig up a spare set, I'll include them.
$ to your door in the U.S.
No trades, please.
Last edited: