Any craftsmen out there that make push daggers please PM me. Pretty simple design... I can draw you up a rough pattern. Something with about a 4 to 4.5 inch double edged blade, handle that slightly angled (I need to measure the angel of my grip) with a slightly wide handle as I want an impact point on the bottom and a thumb ramp on the top. Shouldn't make it any more difficult to make. I'm kind of open on steels. And I'm open on Stainless Vs Carbon. I just want something tough with good edge holding qualities like S90V or 3V or the like. If you dabble in super steels like 10V or 15V or S110V or S125V that would be interesting. But I'm comfortable with good ole standards like 1095, 5160, CPM 154, CPM S30V, and the like. All details can be worked out.
Thanks
Thanks