-
The BladeForums.com 2024 Traditional Knife is available! Price is $250 ea (shipped within CONUS).
Order here: https://www.bladeforums.com/help/2024-traditional/
Looking for a Volunteer OP/Moderator
- Thread starter SLOW2RUN
- Start date
- Joined
- May 25, 2007
- Messages
- 1,157
What?
Jim, he's talking about the ideas discussed here:
http://www.bladeforums.com/forums/showthread.php?t=744522&page=4
http://www.bladeforums.com/forums/showthread.php?t=744522&page=4
Over on the support forum I asked the possibility of getting a 'stickied' thread outlinging and detailing hawk mod procedures and the reply was affirmative.
I would be happy to get this rolling but I am one of the newer freaks in this show so if someone else wants to take this on I'm fine with that. So suggest yourself or someone else. So I am suggesting that I will outline and then detail a long post describing hawk modification, start to finish. Member input will be solicited of course, and specific requests for contributions may be made.
I will await input on the above process. If none is forthcoming I'll draft the document and post in a separate thread, something like "Development of CS 'Hawk mod instructions".
Thoughts?
I would be happy to get this rolling but I am one of the newer freaks in this show so if someone else wants to take this on I'm fine with that. So suggest yourself or someone else. So I am suggesting that I will outline and then detail a long post describing hawk modification, start to finish. Member input will be solicited of course, and specific requests for contributions may be made.
I will await input on the above process. If none is forthcoming I'll draft the document and post in a separate thread, something like "Development of CS 'Hawk mod instructions".
Thoughts?