The GEC Pony Jack is one of my favorite patterns and I'm wondering about having one made with modern steel. Not too picky on what type. S30v, 154, ATS34, etc., is fine.
Scale material could be G10, something along those lines.
I'd pretty much want the knife nearly the same as the GEC version.
I could send a knife along to go by. My concern would be that the cost would far outweigh the benefit.
If someone is interested, it's probably best to email. jfreeborn58 at gmail dot com
Thank you!
Joe
Scale material could be G10, something along those lines.
I'd pretty much want the knife nearly the same as the GEC version.
I could send a knife along to go by. My concern would be that the cost would far outweigh the benefit.
If someone is interested, it's probably best to email. jfreeborn58 at gmail dot com
Thank you!
Joe
