Magnacut Hunter/Skinner Set **SOLD**

TK Steingass

TK Steingass

Troglodyte Knifemaker
Knifemaker / Craftsman / Service Provider
Feedback: +108 / =0 / -0
Joined
Oct 16, 2010
Messages
5,770
Gentlemen:

For your consideration is this Wayne Clay inspired hunter skinner in CPM Magnacut/Bastogne Walnut. The skinner is my interpretation of the Clay Alaska/Safari skinner and the hunter is my interpretation of the Walker Special. The Magnacut material is the next step up in high performance blade material with ultra fine grain and toughness. These knives have been heat treated to Rc 63-64 which I believe is manageable because of the super fine grain structure and toughness for light duty field knives. I hope you like them! $850 delivered CONUS. Paypal preferred to tsteingass@yahoo.com. Thanks for viewing and all comments appreciated.

V/R,

TK

.150" Magnacut stock
HT to Rc 63-64
Skinner 8 3/4" OAL - 4 1/4" BL
Hunter 8 1/4" OAL - 3 7/8" BL
Hollow ground blades
220 Grit belt satin finish
Stabilized fiddleback Bastogne Walnut
Radiussed spines with thumb serrations
Soldered guards
Stainless fittings with black G-10 spacer
Deerskin lined sheaths
Dual and single (hunter) sheath

Magnacut-Knives.jpg
magnacut-sheaths.jpg
 
Last edited:
ONeill said:
Beautiful set TK , how did you like working the new steel ?
Click to expand...
Thanks Jack! I didn't find it much different than working CPM 3V - it's a bit tougher/harder/wear resistant so the best finish I can get is a satin belt 220 finish. :) I think the performance of the steel will be impressive due to the super fine grain structure and corrosion resistance. This is amazing stuff.
 
Very cool, I heard a lot of good things about that steel.
 
Thanks for the kind words fellas. :)

**SOLD**
 
Last edited:
You must log in or register to reply here.
Back
Top