Magnacut Kwaiken *Sold*

[Joshua Fisher]

Hello Everyone, I’ve got one more Kwaiken available this week. This one is in Magnacut hardened to 62-63rc with a satin finish. This model has a 3” blade and 3.5” handle, the handle material is maroon richlite and it comes with a leather pocket sheath from JRE industries. *Sold*

 

[Grady slaughter]

Beautiful wicked knife! Great look on the richlite too.

 

[Joshua Fisher]

Beautiful wicked knife! Great look on the richlite too.

Thank you! I’ve really been liking how the Richlite handles materials have been turning out.

 

[Grady slaughter]

Thank you! I’ve really been liking how the Richlite handles materials have been turning out.

Your scales look great; how fine did you sand them? I have enjoyed working with it too.

 

[Joshua Fisher]

Your scales look great; how fine did you sand them? I have enjoyed working with it too.

I finish most handle material to 320, I find that gives a nice polish but still has a good grip, if I go higher than that I find most handle materials start to get slick.

 

[Grady slaughter]

I finish most handle material to 320, I find that gives a nice polish but still has a good grip, if I go higher than that I find most handle materials start to get slick.

Thanks for your rapid response Joshua. Nice work.

 

[traumkommode]

What is the thickness of the bladestock and (estimated if you don't know) thickness behind the edge? Looks very interesting and like it is ground very thin, which I like.

 

[Joshua Fisher]

What is the thickness of the bladestock and (estimated if you don't know) thickness behind the edge? Looks very interesting and like it is ground very thin, which I like.

Spine thickness is .088” and behind the edge thickness is .010-.012”. Pretty thin for both

 

[traumkommode]

Spine thickness is .088” and behind the edge thickness is .010-.012”. Pretty thin for both

Oh mama, okay thanks. That sounds wonderful. I wasn't planning for this but I might need it, lemme chew for a bit.

 

[Joshua Fisher]

Oh mama, okay thanks. That sounds wonderful. I wasn't planning for this but I might need it, lemme chew for a bit.

Sounds good, not to pressure you or anything haha but this one is thinner at the spine then I normally use. Most of the time I’m using 3/32” stock which ends up being around .105-.110 at the spine.