Maker's Z-Wear Blade SOLD

Status
Not open for further replies.
waterstoneblades

waterstoneblades

Feedback: +17 / =0 / -0
Joined
Sep 17, 2013
Messages
551
Untitled by matt peter, on Flickr
Untitled by matt peter, on Flickr
Untitled by matt peter, on Flickr
Untitled by matt peter, on Flickr

Here is a image of a similar sheath.
Untitled by matt peter, on Flickr

I made two knives in this pattern and this is the test blade I was playing with to get a feel for the steel grade. The knife has very light superficial scratches from the kydex sheath. Z-Wear has a fine grain structure with good toughness, strength and wear resistance.


Specs:
Steel: .110" Zapp Z-Wear Tested at 62/63 HRC
Blade length: 4 3/4", mill flats FFG
.010" edge shoulders approximately 15 DPS
OAL 9 3/8"
Handle: Highly contoured canvas micarta, orange and blue liners and brass hardware
Sheath: kydex, large tek-lok compatible
Price: $170 USD plus $15 shipped to Canada and USA only
Pay Pal or EMT


International buyers can contact me for more information and shipping rates.
Best reach by PM or Email
Paypal,EMT
First "I'll take it" gets it
waterstoneblades@gmail.com is my PayPal address
 
Last edited:
I love the looks of this. Looks so handy, bet it cuts like a dream. :thumbup:
 
Brummie, the balance point is just beyond the forefinger choil. The tang is drilled out and the blade has a generous amount of double distal taper.
 
Last edited:
Status
Not open for further replies.
Back
Top