Periphery415
Gold Member
- Joined
- May 17, 2017
- Messages
- 375
Traded traded traded
Hey there good people of bladeforums,
Today I am looking to sell this Mako Midtech V2. Produced by Millit knives out of Idaho. The knife is in very good condition and has not been used other than to cut some paper.
The action is good, but it may take a little tweaking of the pivot to get it where you like. It was a bit tight when I received it, and I had to ever so slightly loosen the pivot. I have not used any loctite, but once you get it dialed in I would imagine that a drop of blue loctite would be a good choice.
Centering is good, lockup is solid. Over all a very cool blade, just not doing it for me right now.
Asking $traded net via ppf&f shipped in the USA.
I have lots and lots of positive feedback on other sites, dont hesitate to inquire.
Thank you!
Hey there good people of bladeforums,
Today I am looking to sell this Mako Midtech V2. Produced by Millit knives out of Idaho. The knife is in very good condition and has not been used other than to cut some paper.
The action is good, but it may take a little tweaking of the pivot to get it where you like. It was a bit tight when I received it, and I had to ever so slightly loosen the pivot. I have not used any loctite, but once you get it dialed in I would imagine that a drop of blue loctite would be a good choice.
Centering is good, lockup is solid. Over all a very cool blade, just not doing it for me right now.
Asking $traded net via ppf&f shipped in the USA.
I have lots and lots of positive feedback on other sites, dont hesitate to inquire.
Thank you!
Last edited:
