- Joined
- Apr 13, 2005
- Messages
- 913
Hello Everyone,
This knife already has drawn blood.....MINE>...... This knife is 1084 tool steel that has been edge quenched and glass bead blasted. The knife is a full tang design with two brass 1/4" pins and Stabilized Maple.
The knife supports a flat ground blade that has a nice distal taper, and has a sweet swoop to the quench hardening line...... The knife was forged, flattened, normalized, and hardened twice. This knife is stamped with my name.
The knife comes with a side sheath that will be made after purchase so pick a left or right side carry.... Thanks for looking and check out my other knives
just email... at dpknifemaker@aol.com
Measurements are:
Length: 7 1/4" long overall
Width: 1 3/16" widest point
Thick: 1/8" tool steel
Edge: 3 3/4" cutting edge
Handle: 3 3/4" end to choil
This knife already has drawn blood.....MINE>...... This knife is 1084 tool steel that has been edge quenched and glass bead blasted. The knife is a full tang design with two brass 1/4" pins and Stabilized Maple.
The knife supports a flat ground blade that has a nice distal taper, and has a sweet swoop to the quench hardening line...... The knife was forged, flattened, normalized, and hardened twice. This knife is stamped with my name.
The knife comes with a side sheath that will be made after purchase so pick a left or right side carry.... Thanks for looking and check out my other knives
just email... at dpknifemaker@aol.com
Measurements are:
Length: 7 1/4" long overall
Width: 1 3/16" widest point
Thick: 1/8" tool steel
Edge: 3 3/4" cutting edge
Handle: 3 3/4" end to choil
