McFeely’s Pocketwrench 2 - SOLD

Status
Not open for further replies.
jd_elam

jd_elam

Gold Member
Feedback: +405 / =0 / -0
Joined
Feb 28, 2006
Messages
2,883
I have a couple of McFeely Pocketwrench 2’s I would like to sell.

These are made in the USA from 420 stainless steel and are 1/8" thick, 4" long, and 1" wide. The wrench will tighten or remove nuts from 3/16" to 11/16" or 5mm to 17mm. One end is tapered for use as a pry or a screwdriver and there is a 1/4" hex hole for hex bits. Front side is also marked with standard and metric scales.

These are new and unused.

My asking price is SOLD for the pair shipped in the U.S. only.
 
Last edited:
Interested in a 1986 NKCA knife made by Gerber for the 2? It's new, but no box. They bring anywhere from around $50-$70 on Ebay. Here is mine. It is # 1120 of 3500 made I think it was. Thanks for your time.

21mw0hw.jpg

2d0e4ao.jpg
 
fnhfive7 - not really looking for trades at this time.

crocogator106 - E-mail me.
 
Last edited:
Status
Not open for further replies.
Back
Top