Mcnees and Calavera

[bozo1984]

Mcnees custom, 3 1/4” CPM 154 blade, 4 1/4” closed. Anodized titanium frame, runs on bearings, strong detent, blade is centered. Has been carried some, minimal wear on the frame. Blade has satin flats with stonewashed grind, blade has been sharpened with a wide but consistent bevel towards the point, original edge had a high angle, price is adjusted for the edge change. Would make a great EDC. Price sold

Calavera Cutlery (Robertson) large El Patron, 3V blade, dark stonewashed runs on washers, has been carried some but minimal signs of use, edge is sharp.
Price $500 PayPal F&F or $525 G&S, CONUS only.

 

[Mainecobra]

Hows the pivot screw? The hardware on the Gen 2 were very soft and tend to round easily. Can you shoot me a email adamd28@hotmail.com

 

[bozo1984]

Email sent

 

[DEdestroyer]

Is the Calavera still available

 

[Mainecobra]

Hows the pivot screw? The hardware on the Gen 2 were very soft and tend to round easily. Can you shoot me a email adamd28@hotmail.com

Thank you. I appreciate the email.

 

[bozo1984]

Yes it is still available

 

[DGI]

i'll take the mcnees if its still available