Micarta Friction Folder ((SOLD))

wwells20

wwells20

Feedback: +15 / =0 / -0
Joined
Dec 31, 2004
Messages
1,907
6 7/8" OAL.
Black canvas micarta with a Black/Orange layered G-10 back spacer.
3/16" pivot, stop pin and standoffs.
Satin screws and hardware.
2 7/8" CPM 154 flat ground from .125 stock. Rides on over sized bronze washers.
Heat treated by Peters' to hrc 61/62 with a cryo temper cycle.
Right hand tip up carry. (I can set it up for left hand carry if needed)

Asking $150.00 ((SOLD)) shipped to US and territories.
PayPal preferred at wwells63@aol.com. Your satisfaction or money refunded.
First "I'll take it", gets it.
Thanks for looking.






 
Last edited:
Dang, Walter! That's one heckofa grind!!
Gang, Walter makes working knives. Some one get this!
rolf
 
Lycosa you buy , I'll try-it. :D It is a very nice looking blade, though! I'd take the clip off and keep it in a pocket sheath, but that's just my preference. I have a feeling your prices are gonna rise! GLWS.
Thanks, Neal
 
neal70 said:
Lycosa you buy , I'll try-it. :D It is a very nice looking blade, though! I'd take the clip off and keep it in a pocket sheath, but that's just my preference. I have a feeling your prices are gonna rise! GLWS.
Thanks, Neal
Click to expand...

Thank you sir.
 
You must log in or register to reply here.
Back
Top