Bill Siegle
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 3, 2000
- Messages
- 6,869
Here’s a neat variation based off my Mike’s Knife design. Little longer blade, thicker blade(1/4in 5160), and a hammer pommel. I built this for my own use over the Fall but the planned trip never happened and it got set aside. It lay forgotten till I found it tonight and decided to send it off to be used properly 
It’s 12oz of 5160 steel and maroon/black G10 with a blued finish. The choil has a ferro rod scraper ground in. The sheath is black Boltaron with a right hand carry belt loop. It is 10 3/8in overall with a 5 3/4in blade tip to scales. As I built it for my own use and abuse it’s not as pretty as it could be but it’s plenty usable and also inexpensive 
$250***sold***shipped in the USA.
It’s 12oz of 5160 steel and maroon/black G10 with a blued finish. The choil has a ferro rod scraper ground in. The sheath is black Boltaron with a right hand carry belt loop. It is 10 3/8in overall with a 5 3/4in blade tip to scales. As I built it for my own use and abuse it’s not as pretty as it could be but it’s plenty usable and also inexpensive $250***sold***shipped in the USA.
Last edited:
