Mill-Drill / Lathe Combo

Jack O'Neill

Gold Member
Feedback: +177 / =0 / -0
Joined
Nov 15, 2007
Messages
7,176
I would like to sell this grizzly Mill/lathe combo . It is basically new , been here for a year but I have only used the mill a few times to cut slots in guards , it still has the shipping grease on it. It is more than I need . Cost $1750.00 to get it here , I will let it go for $1000.00 , you pick it up .

I am a 2 hour drive from Portland , about 3 from Seattle .

attachment.php

attachment.php





View attachment 325996View attachment 325997
 
I've seen people attach their saws like that. I'm going to have to get one. Right now I'm using a saws-all. Not very accurate, and shakes the bench.
 
Wish I lived out west Jack, Im looking for a mill
 
Wish I lived out west Jack, Im looking for a mill

I wish you were to Chris . I would like to move this, it is just more than what I need . I will probably replace it with just a small mill if and when it sells . It is a great deal for what it here with accessories .
 
Wish I lived out west Jack, Im looking for a mill

I wish you were to Chris . I would like to move this, it is just more than what I need . I will probably replace it with just a small mill if and when it sells . It is a great deal for what it here with accessories .
 
Back
Top