Alan Davis Knives
Knife Maker
- Joined
- Jun 28, 2010
- Messages
- 2,249
overall length - 7 3/16" "
blade - 3 3/8" tip to scales x 1" high x about .100" thick with a slightly rounded spine
steel - 52100 carbon heat treated to Rc 59 - 60
blade finish - mill finish on flats, hand rubbed 400 grit on grinds
grind - full flat
scales - stabilized Maple Burl
spacers - white fiber
mosaic pin and lanyard hole - 3/16" copper
sheath -right hand leather made by me
If you notice in the 4th pic, there is a slight gap between the scale and tang (about the thickness of a piece of paper) , when I was glueing the handles up on this one, one of my clamps popped off some time during the night and I did not catch it until it was to late. It is completely filled with epoxy and it made it all the way through sanding the handles down. Because of this I am discounting it, but I still guarantee it.
(Sold) $125.00 + $10 shipping and insurance in the US, international extra. Paypal, money order and most other forms of payment.
Thanks for looking,
Alan
blade - 3 3/8" tip to scales x 1" high x about .100" thick with a slightly rounded spine
steel - 52100 carbon heat treated to Rc 59 - 60
blade finish - mill finish on flats, hand rubbed 400 grit on grinds
grind - full flat
scales - stabilized Maple Burl
spacers - white fiber
mosaic pin and lanyard hole - 3/16" copper
sheath -right hand leather made by me
If you notice in the 4th pic, there is a slight gap between the scale and tang (about the thickness of a piece of paper) , when I was glueing the handles up on this one, one of my clamps popped off some time during the night and I did not catch it until it was to late. It is completely filled with epoxy and it made it all the way through sanding the handles down. Because of this I am discounting it, but I still guarantee it.
(Sold) $125.00 + $10 shipping and insurance in the US, international extra. Paypal, money order and most other forms of payment.
Thanks for looking,
Alan
Last edited:
