Modified EDC 2.0 (Tanto) SOLD

SmithLevi

SmithLevi

Feedback: +22 / =0 / -0
Joined
Jun 13, 2015
Messages
195
I am really happy on how this little guy turned out. The lines are very clean and very symmetrical. My cleanest knife so far! I ground the edge down to around .015 before hand sharpening on a stone. This way takes a whole lot longer but i am happy with the results and dont run the rusk of messing the edge up on my grinder!


Specs

1/4 '' O1 tool steel at ~58 Rc
OAL ~ 7 1/2
Cutting Edge ~ 3''
Green/Black micarta bolster. Tan g10/black liner
Kydex sheath. (in progress. )


Asking $120 Shipped. (My prices will be a little bit more in the future so jump on while its cheaper!)


Paypal is smithlevi44@hotmail.com

IMG_1384_zpsk4uyn0iw.jpg


IMG_1393_zps5lynvhxm.jpg


IMG_1418_zpsfkhon9ih.jpg


IMG_1419_zpstlibin2x.jpg


IMG_1420_zpso3kiwgjv.jpg


IMG_1421_zpsrgo9urtu.jpg


IMG_1422_zpsycopi4so.jpg



I think that covers about every angle so let me know what you think! I am planning on my making a couple more of these in the next few weeks, so let me know if you would like me to make one to your specs!

thanks!
 
Last edited:
That's a beauty. The texture and color combination of handle, bolster and blade are great and it's a practical design and size. I'm sorry I was too late to get it.

I sent you a PM, as I would be interested in getting a similar knife if and when you make more like this one.
 
Last edited:
davidf99 said:
That's a beauty. The texture and color combination of handle, bolster and blade are great and it's a practical design and size. I'm sorry I was too late to get it.

I sent you a PM, as I would be interested in getting a similar knife if and when you make more like this one.
Click to expand...

Got your message and sent an email! Thanks!
 
SmithLevi said:
I am really happy on how this little guy turned out. The lines are very clean and very symmetrical. My cleanest knife so far! I ground the edge down to around .015 before hand sharpening on a stone. This way takes a whole lot longer but i am happy with the results and dont run the rusk of messing the edge up on my grinder!


Specs

1/4 '' O1 tool steel at ~58 Rc
OAL ~ 7 1/2
Cutting Edge ~ 3''
Green/Black micarta bolster. Tan g10/black liner
Kydex sheath. (in progress. )


Asking $120 Shipped. (My prices will be a little bit more in the future so jump on while its cheaper!)


Paypal is smithlevi44@hotmail.com

IMG_1384_zpsk4uyn0iw.jpg


IMG_1393_zps5lynvhxm.jpg


IMG_1418_zpsfkhon9ih.jpg


IMG_1419_zpstlibin2x.jpg


IMG_1420_zpso3kiwgjv.jpg


IMG_1421_zpsrgo9urtu.jpg


IMG_1422_zpsycopi4so.jpg



I think that covers about every angle so let me know what you think! I am planning on my making a couple more of these in the next few weeks, so let me know if you would like me to make one to your specs!

thanks!
Click to expand...
I'd be interested in one if you made more. Do you have any sheath options?
 
You must log in or register to reply here.
Back
Top