More blades

[NickWheeler]

Hi Guys

I have some blades available........




The first round of 3--- These were all hand forged from 1084, ground, heat-treated using my digitally controlled salt bath and commercial quench oil, Rockwell tested, surface ground on the flats, and finish ground by hand. I put the same edge geometry on these that I put on my own fighters/bowies.

They are all fully hardened and tempered to 60 Rockwell. They were ground with a coarse belt, but have been taken down to where they just need to be sharpened to be a knife you can go use.


Blade #1
OAL- 11-1/2"
Blade- 7-3/4"L x 1-7/16"W x ~1/4"T

SOLD $145 shipped in the states

Blade #2
OAL- ~12-1/2"
Blade- 8-1/2"L x 1-9/16"W x 0.215" thick at ricasso

SOLD $160 shipped in the states

 

[NickWheeler]

Blade #3
OAL- ~12-1/2"
Blade- 8-9/16"L x 1-7/16"W x ~1/4"T

SOLD $160 shipped in the states

 

[canineforge]

More nice blades! I'll take #1, Nick.

Thanks, Joe

 

[bacustomknives]

Nice Nick!:thumbup:

 

[Andre Basset]

I'll take #2 cheers

 

[Andre Basset]

Thanks for posting the blades. I'm really stoked.

That makes three blades from you in less than 24hrs... Wew. I got Wheeler'd and will have to recover the rest of the week.

 

[NickWheeler]

You got 'em fellas--- THANK YOU!!!


I have some "sand paper knives" available. I call them that, because I harden/temper them to a very high hardness and use them to cut sandpaper in the shop. The difference is that these are nicer

Cut and ground from 1/8" 1084. Hardened to 62/63 Rockwell. They are NOT baby pry bars, but they'll cut for a long time. They are surface ground nice and flat, and flat ground very thin... with some convex to the tip.

Each one is $40 shipped in the states.

Sorry, I meant to put numbers on the blades with a marker, to make things easy... So let's just say these blades are

#1 is at top
#2 is the middle one
#3 is the bottom one.

All 3 are now sold. Thanks folks!

 

[Grapevine]

I'll take the bottom one with the finger groove in the handle.

 

[wdtorque]

I like that photo where the three blades are
Katty Corner in the shot.
Dozier

 

[Barry Clodfelter]

I'll take number 3 Nick.

 

[NickWheeler]

Thanks guys!

Barry, just to make sure we're on the same page here---- do you want #3 bowie/fighter, or #3 sandpaper knife?

Thanks!!!

 

[VCM3]

Nick if 1 & 2 on the sandpaper blades is available ,I'll take one or both Just let me know & I'll Paypal asap Thank You,-Vince

 

[Barry Clodfelter]

I want the number 3 fighter Nick.

 

[NickWheeler]

Barry, I put your name on the third fighter- Thanks!

Vince, you got 'em buddy- Thank you!

 

[NickWheeler]

Just wanted to put a heads up that all the blades ahead of this post are in the mail.

Thanks fellas!

 

[Mossyhorn]

Thanks Nick.