My Breadknife

Richard338

Gold Member
Joined
May 3, 2005
Messages
7,235
Just finished this breadknife. Its about my fourth knife overall.
It is 1/16" A2 at 60 RC hardness. The handle is macasar ebony with mosaic pins. The handle looks much nicer than the photos.

dsc004140ij.jpg


dsc00420b0gu.jpg
 
Nice serrations filework! Evenness and symmetry on a pattern like that is not easy! For future reference, note the position of the mosaic pins and line up their pattern, but lookin' good!
 
Thanks Tiktock, I noticed the mosaic patterns being off too (once it had set). This was my first crack at these type of pins. Once the epoxy was mixed I was just glad to get everything fit into place. Next time...
 
Very nice work Richard. Those serrations do look good. You are very patient.

Mike
 
Thanks guys, yes I'm very happy with it. Those serrations were quite tedious, but with no belt grinder yet I am doing everything by hand anyway. Now I'm REALLY hooked. I've got a Knut Lie grinder on the way...
 
Back
Top