- Joined
- Feb 13, 2011
- Messages
- 211
This is my first knife for sale here. It's just one I wanted to make. $85 shipped CONUS. I will take Paypal for this "tool", or certified funds.
It is D2, hrc 60-61, heat treated, cryoed, and tested by Peters Heat Treat. It is .170 thick and 10 inches long and is hollow ground on a 36" radius. This makes it more in between flat grinding and normal hollow grinding. Brushed finish via a scotch bright belt (my prefered finish). Handle is red g-10 with brass pins and thong tube. Shows signs of over-peening ( sure aint going anywhere ).
I made this to work hard and didn't spend much time on fit and finish. No sheath, as I need to move some of the blades that aren't accounted for but for the right price I'll add some leather. It handles well and it's balance point is at your first finger.
First pic is overall, second is showing over peening, third is the finish. Please note the third shows black specks of buffing compound, please don't mistake these for pits.
It is D2, hrc 60-61, heat treated, cryoed, and tested by Peters Heat Treat. It is .170 thick and 10 inches long and is hollow ground on a 36" radius. This makes it more in between flat grinding and normal hollow grinding. Brushed finish via a scotch bright belt (my prefered finish). Handle is red g-10 with brass pins and thong tube. Shows signs of over-peening ( sure aint going anywhere ).
I made this to work hard and didn't spend much time on fit and finish. No sheath, as I need to move some of the blades that aren't accounted for but for the right price I'll add some leather. It handles well and it's balance point is at your first finger.
First pic is overall, second is showing over peening, third is the finish. Please note the third shows black specks of buffing compound, please don't mistake these for pits.
