Neck Knife

J. Hoover · May 17, 2010

This one is SOLD, thanks

Final reduction on this one, 65.00 shipped in USA or Canada
I've been wanting to make a neck knife for while now so I finally sat down a few days ago and sketched out several designs then made a template so I could make more if anyone was interested. Anyhow this is the one I decided to do first. Here are the specs:

Steel- O1 X 1/8 tool steel
HT- In house and triple tempered to 58-59 rc
AOL- 5 1/2 inches.
Grind- Flat with serrations on spine
Blade- 2 inches tip to plunge
Handle- 3 inches
Scales- Maroon G10
Hardware- 1/8th 416 stainless pins
Sheath- Kydex , chain is included but not pictured
Asking 85.00 shipped in the USA or Canada. International orders welcome but buyer pays the additional shipping cost
Paypal or USPS M/O preferred
Comments or questions welcome
Thanks for looking

blademinister · May 17, 2010

That is a handy looking little necker.

Buffalohump · May 18, 2010

I can tell just by looking at it that its going to be very comfortable to use. :thumbup:

J. Hoover · May 18, 2010

Thanks for the comments, and yes this one is very comfortable in the hand for a 5 1/2 inch knife. The 2 inch cutting edge is hair shaving sharp, place your thumb up on the serrations and you can apply plenty of cutting pressure. Lay your index finger down the spine for delicate work. It locks into the kydex sheath at two points for a secure handle down carry.

mtnfolk mike · May 18, 2010

very nice Joseph.. that is a cool looking little knife...:thumbup: i like it..

panch0 · May 18, 2010

That is a sweet looking design. I like it too!

Ridge-Runner · May 20, 2010

Would love to see that design just a lil bit bigger to be used as a EDC. Nice looking blade man.

J. Hoover · May 21, 2010

Appreciate the kind words, I might just make a little larger version of this blade Ridge-Runner.

J. Hoover · May 25, 2010

Bumping this one, this little knife conceals well under a t-shirt, but it's still will do some serious work when needed.

Bet That Hurt · May 28, 2010

I'll take it....email incoming......

J. Hoover · May 28, 2010

It's yours Bet That Hurt, thanks. Be careful with this one or it will hurt, scary sharp and ready to work.
Thanks for the responses from everyone who posted. I enjoyed reading each one.