- Joined
- May 21, 2000
- Messages
- 6,250
This is one of my general EDC designs. It's big enough to do most any routine daily task, but small enough that you will actually carry it. It's quite comfortable in hand, and can be carried a variety of ways.
The finish on this particular knife is a little different from some of my recent knives. The flats are taken to 400 grit, then hit with a medium ScotchBrite belt. The hollows are taken to 1200grit, then finished with a fine ScotchBrite belt. This gives a strong contrast between the flats and hollows without being overly reflective.
This knife is ground with a 14" contact wheel. This allows for high/thin grinds that make for excellent cutters.
- ATS-34
- 60 - 61 HRC
- 1/8 Stock
- Fully Sketonized Under Handle
- Black/Tan G10 Scales - Textured by hand Extry grippy! - Stainless Pins
- Thin Hollow Grind
- Razor Sharp
- Slightly over 6.75" OAL, Actual cutting edge of about 2.8"
- Kydex Sheath (Large Tec-Loc Compatible)
$140 Shipped and insured with a tracking numbers in the CONUS.
PayPal or money order preferred.
PayPal Address:
lmjmitchell@gmail.com
Thanks for looking!
The finish on this particular knife is a little different from some of my recent knives. The flats are taken to 400 grit, then hit with a medium ScotchBrite belt. The hollows are taken to 1200grit, then finished with a fine ScotchBrite belt. This gives a strong contrast between the flats and hollows without being overly reflective.
This knife is ground with a 14" contact wheel. This allows for high/thin grinds that make for excellent cutters.
- ATS-34
- 60 - 61 HRC
- 1/8 Stock
- Fully Sketonized Under Handle
- Black/Tan G10 Scales - Textured by hand Extry grippy! - Stainless Pins
- Thin Hollow Grind
- Razor Sharp
- Slightly over 6.75" OAL, Actual cutting edge of about 2.8"
- Kydex Sheath (Large Tec-Loc Compatible)
$140 Shipped and insured with a tracking numbers in the CONUS.
PayPal or money order preferred.
PayPal Address:
lmjmitchell@gmail.com
Thanks for looking!
Last edited:
