1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New model from N690

Discussion in 'Custom & Handmade Knives' started by CaptainIglo, Nov 7, 2018.

  1. CaptainIglo

    CaptainIglo

    14
    Sep 11, 2014
    Hello again everyone! I got here a smaller than usual for me knife which was made out of N690 and was heat-treated at 60 rockwell. Total lenght is 22.5cm and 4mm at the thickest point. Kydex sheath with paracord to hang on the neck or to mount horizontal on a belt. Polished at 800 grit and then buffed. All input is welcome.

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
     
    herdbull likes this.
  2. john april

    john april KnifeMaker / Craftsman / Service Provider Knifemaker / Craftsman / Service Provider

    Feb 27, 2006
    very nice blade shape. as far as input, if all the holes in the handle had the same 1/8" space between them, it would look more artistic and uniform.
     
  3. CaptainIglo

    CaptainIglo

    14
    Sep 11, 2014
    I totally agree with you but the goal in the beginning was to install handles. For some reason I never did though. Maybe I will because as I said you are right, the holes should have been symmetrical.
     

Share This Page